User's Manual

To continue in setup, press the ▼ Navigation Button [oval 16] to move the cursor next to: BACK

TO T/P CODE PROG. Press the Set Button [oval 18]. Press the ▼ Navigation Button [oval

16] again to move the cursor next to: BACK TO T/P CNTL SETUP. Press the Set Button [oval

18]. The TV/PROJ CONTROL SETUP screen will appear.

To program SCREEN UP/DOWN, LIGHTING ON/OFF, CURTAIN OPEN/CLOSE, press the

▼/▲Navigation Button [oval 16] to move the cursor next to: BACK TO REM CNTL SETUP.

Press the Set Button [oval 18]. See the Screen and Lighting sections following.

If a particular brand or functional codes from a source type cannot be found in the on-board IR

code Library, IR commands for TV/Projector ON/OFF can be taught to the AVR from the original

equipment remote. To teach TV/Projector ON/OFF codes to the AVR, proceed to section: LEARN

CODE.

TV/Proj Program (Learn Code)

To teach the AVR21EN TV/Projector ON/OFF codes, in the TV/PROJ CONTROL SETUP screen,

press the ▼ Navigation Button [oval 16] to move the cursor next to: LEARN CODE. Press the

Set Button [oval 18]. The TV/PROJ CODE LEARN screen will appear.

With the cursor positioned next to USING THE ◄ ► KEYS line, press the Set Button [oval 18].

The message: USING THE ◄/► KEYS SELECT FUNCTION TO BE PROG will start to flash,

indicating a function can be selected for learning. Press the ◄ Navigation Button [oval 16] to

select TV/PROJ POWER ON. When the ON function appears, press the ▼ Navigation Button

[oval 16] to position the cursor next to POINT ORIGINAL REM TO AVR DISPLAY PRESS KEY.

Press the Set Button [oval 18]. The POINT ORIGINAL… message will start to flash. Point the

original remote toward the IR Sensor [square 31]

in the Information Display square 25] on the

AVR front panel and press the button with the original code until the message stops flashing and

CODE LEARNED appears on screen.

The cursor will automatically return to the USING THE ◄ ► KEYS line. Repeat steps above to

program the OFF command.

If CODE NOT LEARNED appears, try to learn the code again. In some cases, it may be a good

idea to replace the original remote’s batteries to improve signal output from the remote. In some

cases, there will be codes that the AVR just is not capable of learning. Contact the Audioaccess

Technical Service Department for advice in such a case.

Test TV/Projector Code

To test the TV/PROJ ON/OFF commands the AVR21ENR1 remote must be configured for HT

MASTER ON/OFF ENABLED.

Press and hold the REM MENU Button [oval 36] on the remote until the Set Button [oval 18]

lights red. Press the ▲ Navigation Button [oval 16] TWICE so HT MASTER ON/OFF shows in

the remote’s LCD Information Display. Press the Set Button [oval 18]. Press the ▼/▲

Navigation Button [oval 16] until ENABLED appears in the display. Press the Set Button [oval

18]. SAVING will appear briefly in the remote display and then SAVED will flash four times. The

HT MASTER ENABLED configuration is now set and the remote will automatically return to

operational mode.

Press the TV Button on the remote. TV should appear in the remote display. Press the ON

Button [oval 2] on the remote. The TV/Projector just configured should turn ON. Press the OFF

Button [oval 1] on the remote. The TV/Projector should turn OFF. NOTE: If the TV/Projector

does not respond, be sure an IR emitter is properly connected to the Control Out All Jack

[circle 35] on the AVR rear panel and properly attached to the TV/Projector.

To return to normal operation mode press the AVR Button [oval 5] on the AVR21ENR1 remote.