User's Manual

Invert Code

Press the ▼/▲Navigation Button [oval 16] to move the cursor next to: INVERT CODE. Press

the ◄/► Navigation Button [oval 16] to select YES/NO. Most devices will be set to NO. Certain

devices, (Sony S-Link, Harman Kardon Remote Control IN) will require a YES setting. Try

changing this setting if a specific code selection does not work for a given device.

Program Code

Press the ▼/▲ Navigation Button [0val 16] so that the cursor is pointed to the PREOGRAM

CODE line. Press the Set Button [oval 18]. The TV/PROJ CODE PROGRAM screen will appear.

TV/Proj Program Code (Manual)

Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the MANUAL line.

Press the Set Button [oval 18]. The TV/PROJ MANUAL PROG screen will appear. SOURCE

TYPE will be fixed as selected (TV/PROJ).

Press the ▼/▲Navigation Button to move the cursor next to: BRAND. Press the ◄/►

Navigation Button [oval 16] to select the appropriate brand.

Press the ▼/▲Navigation Button [oval 16] to move the cursor next to: TRY CODES. With the

AVR21ENR1 Main Room Remote pointing toward the AVR front panel, starting with 1, slowly

press the numeric buttons through the range indicated on screen, until the unit being configured

turns off. When the unit turns off, press the ▼/▲Navigation Button [oval 16] to move the cursor

next to: YES. Press the Set Button [oval 18]. This will ‘save’ this code group for ON/OFF control

of the TV/Projector.

If no IR ON/OFF commands were found, see Automatic and Learn, below.

If no further programming is required, press the AVR Button [oval 5] on the AVR21ENR1 remote

and then the Exit Button [oval 17] to return to normal operation mode.

To continue in setup, press the ▼ Navigation Button [oval 16] to move the cursor next to: BACK

TO T/P CODE PROG. Press the Set Button [oval 18]. Press the ▼ Navigation Button again to

move the cursor next to: BACK TO T/P CNTL SETUP. Press the Set Button [oval 18]. The

TV/PROJ CONTROL SETUP screen will appear.

To program SCREEN UP/DOWN, LIGHTING ON/OFF, CURTAIN OPEN/CLOSE, press the

▼/▲Navigation Button [oval 16] to move the cursor next to: BACK TO REM CNTL SETUP.

Press the Set Button [oval 18]. See the Screen and Lighting sections following.

TV/Proj Program Code (Automatic)

If ON/OFF codes could not be found by Brand in the Manual Mode, try searching by source type

in the Automatic mode.

In the TV/PROJ CODE PROGRAM screen, press the ▼/▲Navigation Button [oval 16] to move

the cursor next to: AUTOMATIC. Press the

Set Button [oval 18]. The TV/PROJ AUTO PROGRAM

screen will appear.

The SOURCE will be fixed as selected (TV/PROJ). Press the ▼ Navigation Button [oval 16] to

move the cursor next to: TRY CODES. Repeatedly press the ◄or► Navigation Button [oval 16]

to test all selected device type commands until the unit turns off. When the unit turns off, press

the ▼ Navigation Button [oval 16] to move the cursor next to: YES. Press the Set Button [oval

18] to ‘save’ the code group. This will set this code group for ON/OFF control of the TV/Projector.

If no further programming is required, press the AVR Button [oval 5] on the AVR21ENR1 remote

and then the Exit Button to return to normal operation mode.