User's Manual

Navigation Button [oval 16] to test all selected device type commands until the unit turns off.

When the unit turns off, press the ▼ Navigation Button [oval 16] to move the cursor next to:

YES. Press the Set Button [oval 18] to ‘save’ the code group.

Press the Exit Button [oval 17] to exit Menu. Press the appropriate Input Selector [oval 4] on

the AVR21ENR1 remote to select the source and then press various control buttons, (Play, Stop,

Track, numeric functions, etc) to confirm IR codes. If some commands are missing (not included

in the library) or if no proper code group was found, they can be added individually by using the

LEARN CODE option in CONTROL SETUP.

If the appropriate code group has been configured, return to the REMOTE CONTROL SETUP 1

screen to configure the next source’s IR codes. Repeat until all sources are setup for IR control.

LEARN CODE

If specific commands are missing from Program Setup (not included in the library), if no proper

code group was found, or if a special command is required, they can be added individually by

using the LEARN CODE option in CONTROL SETUP.

To open the LEARN CODE screen, press the Menu Button [oval 44] on the remote to bring the

MAIN MENU to the screen. Press the ▼/▲ Navigation Button [oval 16] so that the cursor is

pointed to the REMOTE CONTROL SETUP line. Press the Set Button [oval 18]. The REMOTE

CNTL SETUP 1 screen will appear.

Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the source to be

configured. (For example Disc 1 will be used.) Press the Set Button [oval 18]. The DISC 1

CNTL SETUP screen will appear. Press the ▼/▲ Navigation Button [oval 16] so that the cursor

is pointed to the LEARN CODE line. Press the Set Button [oval 18]. The DISC 1 CODE LEARN

screen will appear. (Figure 35)

Figure 35 Source Code Learn Screen

With the cursor positioned next to USING THE ◄ ► KEYS line, press the Set Button [oval 18].

The message: USING THE ◄/► KEYS SELECT FUNCTION TO BE PROG will start to flash,

indicating a function can be selected for learning. Press ◄/► Navigation Button [oval 16] to

scroll through the AVR21ENR1 remote buttons available for programming. When the desired

function appears, press the ▼ Navigation Button [oval 16] to position the cursor next to POINT

ORIGINAL REM TO AVR DISPLAY PRESS KEY. Press the Set Button [oval 18]. The POINT

ORIGINAL… message will start to flash. Point the original remote toward the IR Sensor [square

31] in the Information Display [square 25] on the AVR front panel and press the button with the

original code until the message stops flashing and CODE LEARNED appears on screen.

The cursor will automatically return to the USING THE ◄ ► KEYS line. Repeat steps above

until all individual codes have been learned.