User's Manual

Figure 32 Source Control Setup Setup Screen

Carrier

With the cursor positioned next to CARRIER, press the ◄/► Navigation Button [oval 16] to

select the proper setting. Press the Set Button [oval 18]. NOTE: Most IR remotes used with

common source components will have a carrier, so YES should be selected as a first test. Some

Cable Box remotes do not use a carrier, so if the CARRIER: YES setting doesn’t work, try

changing the setting to NO.

There are two options for programming IR codes:

PROGRAM: This option uses a setup screen to configure IR commands from the on-board IR

code library. This method will be effective for programming most devices.

LEARN: This option allows individual buttons to be programmed for specific IR codes as desired

from other IR remotes. This method would typically be used to add a particular command that is

not included in the on-board library.

PROGRAM CODE

With the cursor next to PROGRAM CODE, press the Set Button [oval 18]. The DISC 1 CODE

PROGRAM screen will appear.

Manual Prog.

Selecting this mode will allow you to manually select the type of device (DVD, SAT, etc.), brand

(Sony, Toshiba, etc) and code group for a specific device. This method is more direct and will be

a little faster than the automatic mode which will search the entire library for codes.

Press the ▼/▲ Navigation Button [oval 16] so that the cursor is pointed to the MANUAL line.

Press the Set Button [oval 18]. The DISC 1 MANUAL PROG screen will appear. (Figure 33)

Press the ▼▲Navigation Button [oval 16] so that the cursor is pointed to SOURCE TYPE.

Figure 33 IR Manual Program Screen