User's Manual

78
When all delay settings made using the menu system have been completed, press the
▼/▲Navigation Button [oval 16] until the cursor is pointing to the BACK TO MAIN MENU line
and press the Set Button [oval 18].
REC OUT
The REC OUT line gives you the opportunity to select which type of audio signal is directed to the
Record Output Jacks associated with VR [square 5], and AUX [square 8]. The default setting is
ANALOG, which will send the analog signal from any source to all three sets of analog record
outputs.
In cases in which you wish to have the output of a digital source selected as the record output
feed, with the cursor next to REC OUT , press the ◄/► Navigation Button [oval 16] so that DSP
DOWNMIX appears. When this indication is shown, the AVR will feed a downmixed, analog version
of a Dolby Digital or DTS encoded signal to the Record Output jacks associated with VR [square
5], AUX [square 8] and the Game/Cam [squares 19, 20, 22, 23] AVR front panel jacks (when
they are configured as outputs). This enables you to make an analog recording (where permitted
by copyright laws) of the soundtrack from a digital source.
As a reminder, to ensure that a signal feed is always available to the record output jacks, we
recommend that an analog connection be made as a fallback for all digital sources. This is key
with sources such as cable set-tops to ensure that a record feed will continue in the event that the
digital audio stream is not available when channels are changed.
When all needed adjustments have been made, press the ▼/▲ Navigation Button [oval 16]
until the cursor is next to VIDEO MONITOR SETTINGS, to make additional Main Room
adjustments or BACK TO MAIN MENU to continue with the system configuration or press the Exit
Button [oval 17] on the remote to return to operational mode.
VIDEO MONITOR SETTINGS
The VIDEO MONITOR SETTINGS are global, rather than input-dependant, as there is only one
Main Room display connected to the AVR. The settings here are primarily changes to the video
enhancement level and aspect ratio for a specific type of device, and defaults were selected after
testing on a wide range of product brands. To change this setting, press the ▼/▲ Navigation
Button [oval 16] so that the on-screen cursor is pointing to VIDEO MONITOR SETTINGS and
then press the Set Button [oval 18]. The VIDEO MONITOR SETTINGS screen will appear.
(Figure 30)
Figure 30 Video Monitor Settings Screen
Press the ◄/►Navigation Button [oval 16] to select from among the options shown for the type
of display that is connected to the AVR21EN. The options are: