User's Manual

58
Input Setup
The first step is to configure each input. Once an input is configured, the selection of an input will
automatically recall those settings from a nonvolatile memory. For that reason, the procedures
described below must be repeated for each input source so that you have the opportunity to
customize each source to your specific listening and viewing requirements. However, once made
they need not be changed again unless you need to alter a setting. When using the full-OSD
system to make the setup adjustments, on the remote, press the AVR Button [oval 5] once
followed by the MENU Button [oval 44] so that the MAIN MENU appears.
Clock Setup
When the Main Menu Appears, the first item to be set is the system clock. The cursor will be next
to the CLOCK SETUP line. Press the Set Button [oval 18] and the CLOCK SETUP (Figure 17)
will appear on the screen.
Figure 17 Clock Setup
With the cursor next to HOUR, press the ◄/►Navigation Button [oval 16] to set HOUR. Press
the ▼/▲ Navigation Button [oval 16] to move the cursor to MINUTE. Repeat these two steps
until AM/PM, YEAR, MONTH, DAY and DAYLIGHT SAVINGS have been set to local time.
When finished, press the ▼/▲ Navigation Button [oval 16] to move the cursor to BACK TO
MAIN MENU. Press the Set Button [oval 18]. The Main Menu will appear.
MAIN ROOM SETUP
In the OSD Main Menu, press the ▼/▲ Navigation Button [oval 16] to move the cursor next to
MAIN ROOM SETUP. Press the Set Button [oval 18] to select the Main Room Setup.
Figure 18 Main Room Setup Screen
System Configuration
The System Configuration setting sets the AVR for the particular speaker configuration being
used. With the cursor next to SYSTEM CONFIGURATION, Press the Set Button [oval 18]. The
System Configuration Menu will appear. Using the ▼/▲ Navigation Button [oval 16], align the