User's Manual

40
50. 12V Trigger Button: Press this button to toggle the 12V Trigger Out Jack [circle 38] on the
AVR21EN rear panel to activate a voltage controlled device such as a screen, lift, lights,
drapes or A/V components. This jack turns on and off with AVR power status. The Trigger
button turns the control voltage from this jack ON/OFF while the AVR is ON.
51. Mute Button: Press this button to momentarily silence the AVR21EN. Press it again, or use
the Volume Up/Down Control [oval 20] to restore audio.
52. EzSet/EQ Microphone Sensor: The microphone sensor that is used by the EzSet/EQ
system is behind the three slots at the top of the remote control. When using EzSet/EQ to
calibrate the AVR21EN, be certain that the slots are not covered. See section: AVR21EN
Configuration/EzSet/EQ for more information on EzSet/EQ.
53. IR Transmitter/Receiver: The infrared emitters and receivers behind the plastic lens at the
top of the remote communicate the remote codes to the AVE21EN and other programmed
devices. Be certain that the lens is not covered when using the remote, and point the lens
toward the AVR21EN for the best results. In learning mode, the remote receives IR codes to
be learned through a receiver behind the lens. See section: Programming The KP21ENR1
Remote Control/Learning Commands for more information on learning remote codes.
NOTE: DO NOT remove the rubber plug that is supplied to cover the jack on the upper right side
of the remote. The jack is not active and is reserved for future use.