User's Manual

185
2. Using the ◄/► Navigation Button [oval 16], set the option for the zone being configured:
YES, NO, ONLY IF ON, ONLY IF OFF.
To exit setup, press the Exit Button [oval 17]. To continue Zone Setup, position the cursor next
to MONITOR THIS ZONE and continue to the next section.
Monitor This Zone
This setting determines whether or not a zone can be ‘listened to’ using the keypad microphone
or ‘viewed’ if the zone being configured has a local video camera installed. Zone Monitoring is
controlled by selecting MONITOR from any keypad’s main menu. When the Monitor button is
pressed, a list of all zones will appear in the keypad’s Information Display [hexagon 13]. When
a zone is selected, a sub-menu of options (AUDIO, VIDEO, AUDIO/VIDEO) will appear. If zone
monitoring has been allowed for a specific zone, one of the three options can be selected. (The
message MONITORED BY KEYPAD X will appear in the Information Display [hexagon 13] on
the keypad of the zone being monitored.)
If NO has been selected in this option the message: CANNOT MONITOR will appear for a few
seconds in the Information Display [hexagon 13] on the keypad in the zone attempting to
initiate Monitor.
If a zone does not have a camera assigned, the message NO CAM ASSIGNED will appear to
inform the user that the system is functioning properly in the absence of a video signal.
To set Monitor This Zone:
1. In the SETUP BY NUMBER PAGE 2 screen, press the ▼/▲ Navigation Button [oval 16] to
position the cursor next to MONITOR THIS ZONE.
2. Using the ◄/► Navigation Button [oval 16], set the permission for the zone being
configured: YES, NO.
To exit setup, press the Exit Button [oval 17]. To continue Zone Setup, position the cursor next
to CAMERA ASSIGNED and continue to the next section.
Camera Assigned
This setting will associate a video camera installed in a particular zone and connected to one of
the Camera Inputs [pentagon 7] on an AVH21, with the Video and Audio/Video Monitoring of
the zone being configured. If the camera installed in the baby’s room (for example Zone 4) is
connected to CAM 4 [pentagon 7] on the AVH21, or AVH21 #1 in systems using multiple AVH’s,
when Zone 4 is being configured, Camera 4 (4) should be selected for this setting. There are 7
camera inputs available for monitoring and there is a NONE option if a zone does not have a
camera installed.
To set Camera Assigned
1. In the SETUP BY NUMBER PAGE 2 screen, press the ▼/▲ Navigation Button [oval 16] to
position the cursor next to CAMERA ASSIGNED
.
2. Using the ◄/► Navigation Button [oval 16], select the camera for the zone being
configured: NONE, 1, 2, 3, 4, 5, 6, 7.
To exit setup, press the Exit Button. To continue Zone Setup, position the cursor next to DOOR
RING and continue to the next section.
Door Ring
Future Feature