User's Manual

176
6. To exit setup and return to system mode, press the Exit Button [oval 17].
Figure 103 Name Paging Groups Screen
Name Paging Groups
Paging Groups are combinations of different zones that can be selected at different times for
Paging. Some typical examples would be paging groups consisting of all bedrooms, just the
children’s bedrooms or a group including the living room, family room and dining room. As part of
the system default, there is an ALL Group to page all zones and each keypad can be selected
individually to page a particular zone. This leaves only the special groupings required by the
homeowner to be setup. It is recommended that you discuss this option with the homeowner to
determine how best to configure this feature.
This section names the paging groups. Building the groups will be done in a later section. To
name Paging Groups:
1. From ZONE SETUP PAGE 1, with the cursor next to NAME PAGING GROUPS, press the Set
Button [oval 18]. The NAME PAGING GROUPS screen will appear. (Figure 103)
2. Press the ▼/▲ Navigation Button [oval 16] to position the cursor next to NAME. Press the
Set Button [oval 18]. A white rectangle will flash to the right of NAME: indicating that the
remote can be used to enter the letters for the group name.
3. Using either the ▼/▲ Navigation Button [oval 16] or the Alphanumeric Buttons [oval 46],
enter the first letter for the group name. (i.e. Bedrooms). When the first letter appears on
screen, press the ► Navigation Button [oval 16] to move the cursor to the next letter
position.
4. Repeat steps 2-3 above until the Paging Group Name has been spelled out. Press the Set
Button [oval 18]. This will store the name and the cursor will appear next to NAME.
5. To name additional groups, press the ▼/▲ Navigation Button [oval 16] to position the
cursor next to GROUP. Press the ◄/► Navigation Button [oval 16] to select another group.
6. Repeat steps 2-4 until all desired Paging Groups have been named.
7. To exit setup, press the Exit Button [oval 17]. To continue Zone Setup, position the cursor
next to BACK TO ZONE SETUP and press the Set Button [oval 18]. ZONE SETUP PAGE 1
will appear.