User's Manual

174
ZONE SETUP
With all system components installed and connected, the system will function to its default
settings. That is, a KP21 can turn the system on, select and control sources and adjust volume, in
addition to some other basic functions.
Figure 100 Main Menu
There are other, more advanced, system functions that require setup, using the same On-Screen
Menu that was used to set up the Main Room, given the use and configuration of every system is
different. To enter the ZONE SETUP mode:
1. In the Main Room, turn on the AVR21EN and main room video display.
2. Press the AVR Button [oval 5] on the AVR21ENR1 MAIN ROOM remote.
3. Press the MENU Button [oval 44] on the remote. The MAIN MENU will appear. (Figure 100)
4. Press the▼ Navigation Button [oval 16] until the cursor is next to: ZONE SETUP.
5. Press the Set Button [oval 18]. The ZONE SETUP PAGE 1 screen will appear.
Figure 101 Assign Services Screen
Assign Services
This menu will configure the multiroom section of the system for various system functions such as
Entertainment, (A/V Sources) Paging, Monitoring, Wake-Up Timers, Sleep Timers and Door
Answer. Any services turned off in this screen will not be available to any part of the multiroom
system. Setting the services by zone is done in a later section. To assign system services:
1. From ZONE SETUP PAGE 1, with the cursor next to ASSIGN SERVICES press the Set
Button. The ASSIGN SERVICES screen will appear. (Figure 101)
2. Using the ▼/▲ Navigation Button [oval 16], position the cursor next to ENTERTAINMENT.
Using the ◄/► Navigation Button [oval 16] select YES to able to select and control the
common A/V sources or NO if this function is not required.
3. Using the ▼/▲ Navigation Button [oval 16], position the cursor next to PAGING. Using the
◄/► Navigation Button [oval 16] select YES to able to talk to other zones using the KP21
built-in microphone or NO if this function is not required.