User's Manual

172
Figure 97 KP21 PREOUT Connections
Speakers
1. Using 16AWG two-conductor stranded wire, strip approximately ¼” and twist the ends until
there are no loose strands that can cause shorts.
2. Insert the twisted ends into the appropriate slots on the R+/R- and L+/L- speaker (SPK)
Terminals [hexagon 24] on the KP21 rear panel as shown in Figure 98, and tighten with a
small blade screwdriver. Pull the wire slightly to confirm connection. Confirm polarity.
3. Terminate and connect speaker ends as appropriate. Confirm polarity.
Figure 98 KP21 Speaker Connections
TV/Video Display
1. Terminate the RG6 quad shield coaxial cable connected to the proper AVH21 zone KP Video
Output [pentagon 2] as appropriate for connection to the composite video input to be used
on the local zone video display. (Most composite video input jacks are RCA type connectors.)