User's Manual

110
button that is being programmed (e.g., the Macro 1 Button [oval 32]) and the indication at
the right side of the top line shows the number of macro steps available of 20 possible steps.
Following the instructions on the remote’s LCD screen, press the first key you wish to be
transmitted in the macro. In our example, we first want the AVR21EN to turn on, so the AVR
ON Button [oval 2] should be pressed.
Figure 61
8. Once the first command button for the macro has been pressed, continue to press the
buttons you wish to be part of the macro, in the order they will be used. Press each button
within five seconds of the last button, remembering to press an Input Selector [oval 4] when
you are changing device functions. As the buttons on the remote are pressed, the remote’s
display screen will show the steps in the macro as they are programmed (Figure 62).
Figure 62
9. For our example, we first want the AVR Power On button pressed, followed by the TV Power
On, followed by the Cable Box On, followed by the selection of channel 201. To do that,
press the buttons in this order:
• AVR [oval 5]
• On [oval 2]
• TV [oval 6}
• On [oval 2]
• CBL/SAT [oval 4]
• 2 [oval 46]
• 0 [oval 46]
• 1 [oval 46]
As each button is pressed to enter it into the macro, you will see the button names appear
and
then scroll up on the LCD display as your confirmation of the key entry.
10. When all commands for the macro have been entered, press the Set Button [oval 18] to
save the macro. The display screen will show the button to which the macro has been
programmed and the number of steps used, and the word SAVED will blink four times in the
lower line of the LCD display. When the display returns to normal, the macro has been
entered and the remote is ready for operation.
11. Macros programmed into one of the three discrete Macro buttons may be activated at any
time by pressing the appropriate button. As the macro plays, you will see the steps appear in
the remote’s LCD display.
Erasing a Macro
Once a macro has been created and stored in the AVR remote’s memory, you have the option of
erasing it. You may do this at any time by following these steps:
1. Press and hold the REM MENU Button [oval 36] for about three seconds while the message
HOLD BUTTON FOR 3 SECONDS appears in the remote’s LCD Information Display [oval
3]. Release the button when the red light under the Set Button [oval 18] appears.