User guide

PC Moderator ™ Installation and User Guide 7

3. Remove the cover to the PC Moderator™ by sliding the cover back toward the

cables until it is off the base panel. You do not need to remove the cover completely

away from the unit. The cables will hold it in place.

4. Identify the correct orientation and plug the PC Moderator™ into the computer’s

VGA port as shown in the photo below. Note that the case of the PC Moderator is

heavy and must be held in place in order to secure the screws in the next step.

Tip: The PC Moderator should plug in correctly. If not, try again with the PC

Moderator turned upside down. If it still does not plug-in, check to make sure you

are plugging it into the VGA video connector and make sure that the connector is a

15 pin type and that pin 9 of the PC’s VGA connector is not plugged (certain older

PCs).

5. While holding the opened PC Moderator™ in place, tighten the two mounting

screws with a small Phillips screwdriver. Tip: Depending on the orientation of the PC

Moderator it may be more convenient to place the PC on its side or front in order to

tighten the set screws. Do not over tighten.

VGA Cable to

Monitor