User guide

PC Moderator ™ Installation and User Guide 23

6. Slide the cover of the PC Moderator™ back on the base as far as it will go. The

hole on the cover should line up perfectly with the hole on the base. If the cover

does not slide on easily, make sure the internal wires do not interfere with the case

cover. If the cover has been removed completely, the cables will need to be fed through

the slit in the bottom of the cover.

7. Attach the monitor’s cable to the VGA cable of the PC Moderator. Tighten the set

screws finger-tight.

8. Unplug the PS/2 style keyboard connector from the keyboard socket on the back

of the computer and plug the keyboard into the short keyboard cable of the PC

Moderator™.

9. Plug the long keyboard cable from the PC Moderator™ into the PS/2 keyboard

socket on the computer (where the keyboard cable was unplugged).

10. Guide the shackle of the padlock through the hole at the center of the back of the

PC Moderator cover and base. Lock the padlock

Tip: You may replace the supplied padlock if desired to any style including combination

types, however, the shackle must not be greater than 7/32” diameter. When using a keyed

lock, keep the keys in a safe place where users do not have access. This preferably should

not be kept in the home unless you are absolutely sure that users cannot access the keys.

Remember that teenagers are both imaginative and persistent so don’t just hide them in a

place where you think that they won’t find it. Do not use luggage locks or very small

padlocks as these can be easily pried open.

11. Make sure the computer is upright and connect the computer’s power cable to

AC power.