Technical data

Maintenance and Cleaning
76 02/2014-v1.0en
Running Surface Does Not Move
 Is the safety magnet activated?
 Does the display function properly?
 If the display and/or the incline are working, unplug the treadmill and wait at
least 60 seconds before reconnecting it to a power supply.
RUNNING SURFACE BELT IS STUCK / IS HARD TO MOVE
 First, determine whether the display is lit and/or whether the incline system
works. This information will help our service technicians to determine where
the cause of the problem could be.
RUNNING SURFACE BELT IS STUCK
 Check for any obstacles, and remove them if possible.
Incline Does Not Function
 Check whether incline motor makes noises (brake stuck/motor has stopped).
 Check whether the incline limit switch has been tripped.
 Check whether the chain is broken or has slipped from the sprocket.
 Check whether the potentiometer is set properly.
Irregular or Flashing Display
 Probable causes: low line voltage; excessive load on the line.
 Ensure that the treadmill is connected to a separate power line.
 The power supply for the display on the interface card is defective.
Squeaking Sounds
 Loud bearing. Contact customer service to replace bearing.
 Toothed belt rubs against the guide roller, try greasing the edge of the belt
with a universal lubricant.
 Running surface belt rubs against the guide roller; try lubricating the teeth on
the drive axle and let the running surface run slowly for a few minutes, so that
the grease is evenly distributed. (NOTE: Excessive grease causes clotting and
collecting of dust).
 Check whether a guide roller or a roller bearing on the carrier rail is broken
and contact customer service if necessary.