Technical data

Maintenance and Cleaning
02/2014-v1.0en 75
9.6 Adjusting and Calibrating
Incline System
The incline system with toothed rack and gear drive is used on WOODWAY tread-
mills. For systems with an incline of 15% to 25% similar components are used.
They only differ with respect to the movement of the toothed rack.
Running Surface Belt
The running surface belt does not usually need adjustment. However, when the
running surface belt or corresponding parts are replaced the belt tension must be
checked.
Treadmill Support Feet
REQUIRED TOOLS: LEVEL, WRENCH
When the treadmill wobbles or seems unstable, the support feet must be checked.
Check both ends of the treadmill with a level. Loosen the locknut and turn the foot
until the correct height is reached. Retighten the locknut.
When the treadmill is moved the frame may bend. If the treadmill seems to wobble,
press down on the railing on either side. This can realign the railing without making
a support foot adjustment necessary.
9.7 Troubleshooting
If you have problems with your treadmill, please consider the answers to the follow-
ing questions before calling customer service:
 What are the make and model and what is the serial number?
 What happened before the problem occurred?
 Did the problem occur suddenly or slowly over time?
 Was the treadmill in use when the problem occurred?
 Was the running surface ENGAGED or is it in DYNAMIC MODE?
 Explain all the other information that you consider relevant.
No Display
If the display is not lit when you turn the treadmill, check the following points:
 Mains input fuse - replace if defective.
 Electrical outlet is working.
 Check outlet with other device (radio, fan etc.). Check main fuse or circuit
breaker, use another outlet.
 Is the treadmill connected to the power source?
 Is the safety magnet applied and in the proper position? Try placing it in an-
other location. Check all circuit board connections.
Note