Technical data

Commissioning
30 02/2014-v1.0en
Fig. 11 Desmo Assembly, Connection 4
- Fix the wires to the frame with the supplied wire
ties.
- Then remount the electronic cover plate.
Fig. 12 Desmo Assembly, Side Covers
- Slide the side covers onto the left and right
sides.
- Guide the covers, slightly tilted under the rubber
railing covers.
- Fix the side covers and railing covers with
screws (do not tighten the screws yet).
Fig. 13 Desmo Assembly, Adjusting Side Covers
- Position the side covers so that a 5 mm gap + X
is visible.
- Then tighten all screws.
Note 1:
The side covers must not be in contact with the
running surface.
Note 2:
The side covers must not be in contact with the
drive belts on the rear left side!