Technical data

Commissioning
26 02/2014-v1.0en
6 Commissioning
6.1 General
Commissioning is the initial intended use of the device, see sec. 2.5 Page 13. En-
sure that the conditions applicable to basic safety and health requirements are met.
Read these operating instructions completely before commissioning.
Before commissioning the device, operating and functional safety is to be tested.
This includes correct installation and operator instruction.
6.2 Installation
Only install your treadmill at ground level on a sufficiently firm, stable surface. The
surface should be as flat as possible to ensure that the frame only bends minimally.
Do not place the treadmill directly on deep pile velour or fleece carpet due to mov-
ing parts on the bottom.
ATTENTION
Maintain the Safety Area!
Keep the area around the treadmill clear, see Fig. 3.
Ensure that there is a clearance of at least 2 meters between the back of the
treadmill and walls or furniture. Sloping ceilings may not extend into this safe-
ty area!
Fig. 3 Set-up, Clearances
If the installation site has high-pile carpeting, a floor protection mat should be
placed under the treadmill.