User Manual

facebook.com/woodsamcom
First time use: hold the marker tip up vertically
and press the tip to release pressure
How to Use?
Before each use, shake well for 10 seconds with
cap on. You should hear the ball-bearings
rattling around inside the marker
Hold the marker vertically and press the tip in for
5-30 seconds until the tip fills with ink on a
horizontal surface. You will see ink start to seep
into the tip. You can pump the tip a few times to
help the process along until the ink floods the tip,
then immediately release pressure on the tip
After using the marker, use a damp cloth or paper
towel to wipe off the drawing. Put the cap back on
the marker till it locks up firmly, otherwise it can
cause a spit in the tip or cause damage to it
Check out the quick instructional
Caring Tip:
Make sure the
cap is on tight
to avoid drying
out
Here