Download mobile app iOS™ 9.0 and later Andriod™ 4.1 and later www.lightpack.
LED strip Ribbon holder TV back side x1 Lightpack x1 x5 x1 LED strip Straight connector Remote control LED cable 2. Lightpack LED cable x1 HDMI x1 Connector x1 Power supply x20 Ribbon holder Watch video instruction on lightpack.tv/start 3.
Installation Installation 1. Stick the Ribbon to the TV 1. Wipe the dust off the back side of TV. The arrows on the Ribbon must be directed clockwise 2. 3. 1-2 cm 5 cm 5 cm 1-2 cm The clip should not cover the LED TV back side Important: Start from the lower left сorner 4. Stick the holder to the TV TV back side 5.
Installation Installation 2. Cut the Ribbon and assemble a). 1. 2. 1. Cut here only Check that the Ribbon and the connector are facing up. TV back side b). 2. Remove the silicone case from the ends red black c). 1,5 cm 6. 7.
Installation Installation 3. Connect the Lightpack 1. TV back side Lightpack backside 1. HDMI 2. Ribbon 3. TV back side 3. Power connector supply Connect the power cable last! 8. 2. If your TV has 16:9 or 16:10 aspect ratio, the Lightpack will setup the Ribbon automatically. Otherwise, do it manually. Go to p.4. 9.
Installation Usage Installation 4. Connecting the Remote to the Lightpack 5. Manual Ribbon setup 1. Press the 1. Press 2. The Remote button (in several places). will start blinking. Media Moods Media Inputs Skip this step if your TV aspect ratio is 16:9 or 16:10. 2. The light spot will start moving. button for 2 sec. Moods Led will light solid green Inputs Inputs TV back side 3. Place the Remote close 4. When connected, the Remote will blink to the Lightpack.
Installation Usage Usage Connecting HDMI sources 3. When the spot reaches a corner, push the Inputs button. TV back side 4. Repeat the process with all corners. Connect at least one HDMI device. TV back side HDMI device HDMI device The light spot will blink indicating that the Lightpack remembered the corner position. Then the spot will continue moving. Upon finishing, the Lightpack will automatically exit the Manual Setup mode and remember the preferences. HDMI device HDMI device 12. 13.
Usage Usage Turn the Lightpack on Switch HDMI input “Moodlight” mode 1. Turn on your TV and switch it to the HDMI mode. 1. Press the 1. To turn on the 2. Turn on the HDMI device connected to the Lightpack. It will turn on automatically. 2 sec 3. To turn the Lightpack on or off manually, button on the Remote or press the button on the Lightpack. It will switch between active inputs, regardless of whether the Ribbon is on or off. Inputs Inputs 14.
20C