Installation Guide

R
ODBRIDGE
ODB
R
OODBRIDGE
WOODB
R
OODBRIDGE
WOODB
W
www.woodbridgebath.com
6
R
WOODBRIDGE
F. A small amount of silicone should be applied around the back of each
plumbing hole penetration.
3. Installation of opposite side wall panel.
A. Use same procedures as in steps 2.A-2.F except that no holes will be
drilled in this panel. Dry fit first, and then apply silicone to seal the back
wall and shower base corner, and adhesive to panel as you did on
previous side panel installation.
4. Seal all joints and check that all areas of panel are held firmly in place.
A. Apply silicone sealant to all corners and verify there are no loose areas
on all panels. Use 2x4 lumber to brace areas if needed until adhesive
cures. (Typically 24hrs depending on ambient temperature)
B. Once cured utilize denatured alcohol and clean painters rags to clean
up any residue from installation.
C. Finish
Customer Service Phone: [phone]. (Monday - Friday 9 AM - 5 PM Pacific Time)
Or Email: [e-mail]