Installation Guide

WOODBRIDGE

www.woodbridgebath.com

How to Measure: Draw a vertical plumb line directly on the middle of the

sheet- rock from top to bottom of wall. Now draw a horizontal level line

crossing the plumb line about halfway up the wall. Record mea- surements

left from the vertical line to corner at top, middle and bottom (L1, L2, L3),

then right from the vertical line to corner (R1,R2, R3.) Now record

measurements down from the horizontal line to the tub (D1, D2, D3.)

Transfer these measurements to your back wall panel (A).

WOODBRIDGE

B. When satisfied with the fit, clean burs from any rough edges. Generously

apply Performance Pro or similar Adhesive in lines or blobs to the back of

the panel in a pattern every 3 to 4 inches. Use approximately one 10oz

tube per 8 square feet following adhesive directions on tube. Push the

panel in place, lightly pounding to achieve good bond. Avoid making an

airtight seal around the exterior as air is needed in the curing process.

Adhesive should be applied as in Fig

D1 D2 D3

Vertical Plumb Line