Installation Guide

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

1. Woodbridge Shower Wall Panels are designed to be installed over a

solid substrate such as green board, cement backer board, or

Densshield. The substrate should be clean, dry, and are of dust and

debris.

2. If installing a new bathtub or shower base prior to Woodbridge shower

wall panel installation, follow the manufacturer’s instructions, and install

the tub or base level and square to the walls.

3. Turn off the water supply and complete any plumbing modifications

prior to installing your. Leave handles and trim off until surround is

installed. Plan the placement of the shower head such that it is either

above the height of the wall panels or at least 2" below the top of the

wall panels. This will allow room for the escutcheon plate.

4. Detail edging products such as Schluter systems can be utilized to

finish exterior edges to match your bath hardware.

Installation

1. Installation of back wall panel.

A. The back panel must be fit to both the left and right corners, and to

the tub or shower base. Keep in mind that walls may not be square or

plumb, so you will want to measure width of the alcove at both the

bottom and top of the alcove prior to trimming panel. (See Fig for a

technique for achieving good fit measurements.) Trim the panel to size

with a utility knife, jigsaw with small tooth metal or carbide blade, and

dry fit until a tight fit is achieved.