Installation Guide

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

!!!Consult your local building codes with questions on installation

compliance standards. Building and plumbing codes may vary by

location, Woodbridge Bath is not responsible for code compliance

standards for your project!!!

Before You Begin

Woodbridge shower wall panel can be installed in both showers and

alcove tub installations. Can be cut to fit any application.

Recommended Tools

• 100% clear silicone sealant, and Performance Pro or similar Adhesive

• Circular saw with 60 to 80 tooth carbide blade

• Jig-Saw with carbide or bi-metal blade (14 teeth per inch)

• Drill with 3/8” drill bit

• Hole saw for shower faucet/shower head

• Tape measure

• Masking tape (2” wide works best)

• Level

• Caulking gun

• Clean paper towels or shop towels

• 2 x 4 lumber, as required for bracing

• Denatured alcohol

Unpacking

• Use care when opening the box so that you do not dam- age the panels.

• This product is shipped to you after careful inspection. After purchasing

the kit, carefully unbox and inspect the product for any shipping damage

that may have occurred. If damage is found, report it immediately to the

source of purchase. After inspection and during installation, protect the

products from construction damage by moving them to another room or

area until ready to install.

• Store panels in a flat area to avoid warpage until the time of installation.

Do not store the panels outside of the original packaging in a vertical

position.

• Please use the model number located on the side of the box or the front

of this manual when contacting us with questions concerning the

installation of this unit.

• Make sure the walls are the correct size and are in good condition.

Installation of damaged product will void the warranty.