Installation Guide

Using the Mirrored Cabinet

1. Light on：When light is off, wave hand 3-5cm below light sensor to turn light on.

2. Light off：When light is on for more than 10 seconds, wave hand 3-5cm under light sensor to turn light

off.

3. Switch light color：When light is turned on or light color is switched for less than 10 seconds, wave hand

under light sensor to switch light color.

4. Adjust light brightness：When light is on, place hand under light sensor for more than 1 second to adjust

light brightness steplessly.

5. Defog: Defogger and power switch controlled at same time.

6. UV sterilization：When this function is off, place hand under UV sterilization sensor for 2 seconds until it

beeps, indicating UV sterilization function is turned on. Place hand under sensor for 2 seconds again to

turn off the function. The function will turned off automatically after 15 minutes or when the right door

is opened.（Only for products with UV sterilization lamp）

2. Turn on power to enter standby mode, and off to

shutdown mode.

Note: Press the test button prior to usage, the reset

switch pops up indicating that the leakage

protection function is normal.

Press the TEST button (then RESET button)

every month to assure proper operation.

1. Insert the leakage protection plug into a power socket,

press the reset switch, plug indicator lights up, indicating

that the power is on.

The socket/USB is located inside the cabinet.

Please shut down the device before cleaning. Do not use any kind of chemical detergent to wipe the

device. It is recommended to use a soft, fine, non-corrosive cloth.

Turning the device on/off

Operation instructions

3 Socket/USB

4 Cleaning the device

Reset switch

Indicator light

Current detection

test button