Instructions / Assembly

ManualsBrandsWOODBRIDGE ManualsHome Spas54 in. 1-Person 0-Jet Standard Cold Plunge Ice Bath Tub/Hot Tub with 1.3 HP High-Performance Chiller and Heater in White

WOODBRIDGE

www.woodbridgebath.com

F01

When the water temperature is eual to or higher than the target temperature, start cooling when the water

temperature is eual to or less than the target temperature , start heating

F02

When the displayed temperature deviates from the actual temperature, this function can be used for calibration.

F03

When there is a deviation between the inlet water temperature and the displayed water temperature, you can

use this function to correct it. When you click on the correction, a pop-up prompt will appear to confirm the

current temperature and then enter the correction numeric keyboard pop-up window.

F04

After clicking on, there will be a 3-minute countdown. If the water pump does not report an error, the

compressor and fan will be started.

F0

Click setting and you will be prompted to enter the password to enter the settings.

F06

Defrost operation, and it will eit defrost when the time is over

F0

Defrost will be eecuted when the continuous operation time of

electric heating reaches the factory setting

F08

Set to 0 Celsius mode set to 1 Fahrenheit mode

F09

imit the maimum value of the target temperature, when the temperature eceeds this set value, the

over-temperature protection will be triggered.

F10

imit the lowest value of the target temperature, when the temperature is lower than this setting, the ultra-low

temperature protection will be triggered.

F11

The current eceeds this setting value and will triggers overload protection when the compressor is working .

F12

If the compressor of working current overload duration is greater than this setting value, then will trigger this

protection.

F13

Set to 0 to display the internal temperature of the evaporator to 1 to display the water inlet temperature

F14

After press the Oone button , it will start counting down according to this setting time. When the countdown

ends, it will stop the Oone to continue working.

F1

The current of the fan eceeds this setting value when the fan is working then will triggers the overload

protection

F16

The current is lower than this setting value when the water pump is working and then will triggers the overload

protection.The monitoring starts after  minutes of power on.

F1-01

The water pump is stuck and there is no water flow

F1-02

The water pump is running normally and the water flow is small

F1-03

The water pump is running normally but no water flow in the waterway

F18

Detect the refrigerant pressure of the chiller system through a pressure switch

F19

The absolute value of the subtraction between the monitored inlet water temperature and the monitored

evaporator internal temperature

F20

Set to 0 All detection function device will invalid. Set to 1 All detection function device will be valid

F21

Automatic screen save time

Parameter annota�on

1 2 3 4 5 6 7 8 9 10

11 12