Instructions / Assembly

ManualsBrandsWOODBRIDGE ManualsHome Spas54 in. 1-Person 0-Jet Standard Cold Plunge Ice Bath Tub/Hot Tub with 1.3 HP High-Performance Chiller and Heater in White

WOODBRIDGE

www.woodbridgebath.com

This product must be installed by a fully insured and licensed HVAC installer.





We are not responsible for local codes compliance for this product. Building and plumbing codes may vary from state-to-

state 







costs in case of the product defect.

The connection instructions in this manual are for general reference. The actual connections may varyby the type of cold

plunge tubs you purchase.

TWO PEOPLE

LIFT REQUIRED

INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING

OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.

READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT

2 PEOPLE ARE REQUIRED TO LIFT AND DURING

ENTIRE INSTALLATION OF THIS PRODUCT

BCH1000

WCH2000

Chiller Installation Instruction

1 2 3 4 5 6 7 8 9 10

11 12

Summary of content (16 pages)

PAGE 1
Chiller Installation Instruction BCH1000 WCH2000 READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION. TWO PEOPLE 2 PEOPLE ARE REQUIRED TO LIFT AND DURING LIFT REQUIRED ENTIRE INSTALLATION OF THIS PRODUCT This product must be installed by a fully insured and licensed HVAC installer. The chiller uses R410A refrigerant.
PAGE 2
PAGE 3
2.Installa�on Instruc�on Chiller installa�on ① Install the chiller in a stable place to avoid the impact of water level backﬂow. The ice tub’s inlet hole should be set to a higher level than the inlet of the chiller. ② Install the chiller in a clean place. Avoid too much debris gets into the tub to block the chiller system. ③ Install the chiller in a well-ven�lated place to facilitate the exhaust of the chiller. Hoses, chiller housing/pipelines, and tub exterior may have condensa�on.
PAGE 4
PAGE 5
PAGE 6
KEY DESCRIPTION ICON Working Logic Display interface And how to do www.woodbridgebath.
PAGE 7
6 7
PAGE 8
PAGE 9
Don’t run the Ozone system when people are in the chiller during cooling or hea�ng because too high zone concentra�on may aﬀect respiratory tract. The ozone life spam is ten thousand hours a�er it reaches those hours, you need to change to a new ozone generator. The ﬁlter mainly ﬁlters hair, dandruﬀ, etc. from entering the chiller system to ensure the normal opera�on of the chiller. If you want to achieve the purpose of purifying water, you can add ﬂocculant and Water puriﬁer for clariﬁca�on treatment. 4.
PAGE 10
5. Circuit Wiring Diagram Fault code www.woodbridgebath.
PAGE 11
www.woodbridgebath.
PAGE 12
Parameter list code Menu content F01 Temperature return difference F02 Range Ex-factory Company 0.
PAGE 13
Parameter annota�on F01 F02 When the water temperature is equal to or higher than the target temperature, start cooling; when the water temperature is equal to or less than the target temperature , start heating When the displayed temperature deviates from the actual temperature, this function can be used for calibration. F03 When there is a deviation between the inlet water temperature and the displayed water temperature, you can use this function to correct it.
PAGE 14
PAGE 15
Useful Tips 1. lt is normal to have condensa�ons on the hoses, chiller housing cover, or around the tub. The condensa�ons happen when these tub/chiller parts are colder than the air around. 2. The fan in the chiller starts running 3 minutes a�er the machine opera�on is normal. 3. A noise level of around 55 decibels is normal. 4. When the temperature reaches the target value, the cooling compressor will stop. The water circula�on pumpcon�nues to run is normal. 5.
PAGE 16
IMPORTANT! DO NOT USE: Abrasive cleaners such as: acid, ammonia, bleach, and similar solutions. Use of such solutions may cause corrosion, finish peeling, and/or dull the surface. DO NOT USE: Abrasive sponges or cloth.