Technical data

Mountain Series CE
Installation and Operation Manual
35
OPERATIONAL SEQUENCE
RFG CE OVEN BURNER OPERATION SEQUENCE
Pilot lights
Power On
ICS2 (ignition) module powers igniter and
opens pilot valve
Pilot does not light, ICS2 module times out,
Controller will flash “chec”�
ICS2 module senses pilot flame, turns
igniter off, SV-2 opens, burner lights,
dome flame light comes on
Burner remains on until oven control is
turned off�
Pilot lights
Power On
RFG-IR CE OVEN BURNER OPERATION SEQUENCE
Radiant burner - ICS2 module
powers igniter and opens pilot
valve�
Pilot does not light, ICS2 module
times out�
ICS2 senses pilot flame, igniter
off, dome flame indicator light
comes on, SV-2 opens, radiant
burner lights�
Radiant burner remains on until
oven is turned off�
IR - If the floor temperature is
above the Hearth Set Point, then
Controller does not power ICS1
module (for underfloor IR burner)�
IR - If the floor temperature is
below the Hearth Set Point, then
Controller sends power to ICS1,
ICS1 powers igniter and opens
pilot valve�
Pilot lights, ICS1 senses pilot
flame, igniter off, Hearth Heat
light on, SV-1 opens, underfloor
IR burner lights�
Floor reaches the Hearth Set Point
temperature� Controller turns off
power to ICS1 and underfloor IR
burner shuts off�
Pilot does not light, ICS1 times
out, Touchpad Controller flashes
“chec”
PERIODIC THERMAL CLEANING