Technical data

Mountain Series CE
Installation and Operation Manual
11
An ongoing program of product improvement may require us to change
specifications without notice. WS-MS-(RFG, RFG-IR)-CE,
Revised May 2014 Doc no: M0037.01
[e-mail] or visit woodstone-corp.com
wood stone corporation
1801 w. bakerview rd.
bellingham, wa 98226 usa
t. +1.360.650.1111
f. +1.360.650.1166
EXTENSION PANEL ASSEMBLY
OPTIONAL LOWER EXTENSION, THROTTLE ROD AND CONTROLLER ASSEMBLY INSTRUCTIONS
1. After the oven has been leveled, remove
the throttle rod assembly which has been
attached to the inside of the stand for
shipping� Position the lower extension
assembly onto the front of the oven� It
will rest on the guides that are welded to
the oven legs� Attach the assembly to the
oven legs using the 1/4-20 nuts, bolts and
washers�
2. Remove the access panel�
4. Remove the throttle knob/pointer section from the throttle assembly� Slip the clamp off of the throttle knob assembly
and slide it over the EMT throttle rod extension� Slip the front of the EMT throttle rod through the throttle rod bracket
at the front of the oven, then slip the other end of the EMT onto the throttle valve at the back of the oven� Note: The
end of the EMT that goes over the throttle valve is drilled to accept a cotter pin� Attach the EMT throttle rod extension
to the throttle valve using the cotter pin and open the end of the pin slightly to prevent it from falling out� Make
certain the valve is in the full open position by turning the attached throttle rod extension counterclockwise
until it stops.
Continued
3. Attach the controller to
the mounting bracket of
the extension using the
1/4-20 bolts provided�
Flame Height
Control Knob
Throttle bracket
(already attached)
Pointer collar /
Pointer assembly
Clamp
EMT throttle
rod extension
Throttle Valve
Cotter pin
Extension panel
throttle assembly