Specifications

15
Mt. Olympus Solid Fuel Rotisserie
Installation and Operation Manual
DAILY OPERATION
SPIT DIMENSIONS
An ongoing program of product improvement may require us to change
specifications without notice. SFR, Revised November 2014.
Doc no: M0057.02
[e-mail] or visit woodstone-corp.com
wood stone corporation
1801 w. bakerview rd.
bellingham, wa 98226 usa
tf. 800.988.8103
t. 360.650.1111
f. 360.650.1166
BEGINNING OF DAY
FUEL THE BROILER
Make certain the ventilation system is turned on and operating properly. See FUELING THE CHARBROILER section for details.
LOADING THE ROTISSERIE
Open both doors to load the rotisserie. The drum will stop automatically anytime the doors are opened. To advance the rotisserie
drum with the doors open, simply depress the GREEN start rotation button to jog the drum. Release the switch when the rotisserie
drum reaches the desired position and it will stop.
NEVER ATTEMPT TO PLACE OR REMOVE SPITS WHEN THE ROTISSERIE DRUM IS MOVING
LOADING THE SPITS EVENLY
The spits can only be inserted into the rotisserie drive one way. When loading the rotisserie, make sure the load is evenly distributed
by loading equally weighted spits and/or baskets opposite each other. The round end of the spit or basket is always inserted first.
Push the round end of the spit into the hole until there is clearance to insert and seat the square end into its socket. Be sure to fully
seat the spit so that it locks into place and the round end will rotate freely when the drum turns.
ROTISSERIE OPERATION
To restart the rotisserie, close the doors and push GREEN start rotation button. The speed
of the rotisserie can be adjusted using the BLACK speed control knob located on the
controller. The rotisserie will stop anytime the doors are opened or when the RED button
is depressed.
NOTE: Except during loading or unloading, the drum should always be moving in the
presence of heat to avoid warping the rotisserie.
1. Insert the pointed end of the
spit into the round hole, which
is opposite the motor side of the
rotisserie.
2.
Then back the other end of the spit
into the square hole on the motor
side.
3.
Make sure that the pointed end of
the spit is backed out of its hole
far enough to allow the spit to turn
freely.
Motor side
SFR-10 CAPACITY
With the 10-spit SFR-10 model,
when using all 10 spits, the
operational maximum product load
will be approximately 6–7 chickens
weighing 2.5 lbs each.
To load larger product, it is
possible to run the rotisserie with
five spits, removing every other
spit for balance.
SFR-6
SFR-10
Using 5 spits
Using
10 spits