Owner manual

KEEP FOR FUTURE REFERENCE

INSTRUCTIONS

International Version

MODEL NUMBER: EO8RC1

RADIO REMOTE CONTROL OPTION

RETROFIT KIT INSTALLATION

FOR MRTALP-DC

READ ALL INSTRUCTIONS AND WARNINGS

BEFORE USING THIS PRODUCT

DESIGNED FOR THE MATERIALS HANDLING PROFESSIONAL

P.O. Box 368 – 908 West Main

Laurel, MT USA 59044

phone 800-548-7341

phone 406-628-8231

fax 406-628-8354

PAGE 1
KEEP FOR FUTURE REFERENCE INSTRUCTIONS P.O.
PAGE 2
PAGE 3
INSTALLATION Tools 1) 7/16" wrench 2) Philips head screwdriver 3) Needle-nose pliers 4) Wire stripper/cutter Disassembly Note: See the Operating Features in the MRTALP-DC lifter's instruction manual to identify any features not clearly shown in the FIGURES to follow. 1) Place the pad frame with the vacuum pads (pad covers on) facing downward on a clean, flat surface. 2) Disconnect the electrical connectors uniting the battery to vacuum generating system.
PAGE 4
Figures FIGURE 1 1) 10-32 X 3/8" PHILLIPS SCREW 4) 1/4" LOCK WASHER 7) CONTROL ENCLOSURE CONNECTOR 2) 1/4" WASHER 5) RADIO RECEIVER ASSEMBLY 8) STROBE LIGHT ASSEMBLY 3) 1/4-20 X 5/8" HEX HEAD SCREW 6) RADIO RECEIVER CONNECTOR FIGURE 2 1) WIRE TERMINAL BLOCK Rev 0.
PAGE 5
LIMITED WARRANTY Powr-Grip products are carefully constructed, thoroughly inspected at various stages of production, and individually tested. They are warranted to be free from defects in workmanship and materials for a period of one year from the date of purchase. If a problem develops during the warranty period, follow the instructions hereafter to obtain warranty service. If inspection shows that the problem is due to defective workmanship or materials, Powr-Grip will repair the product without charge.