User guide

4 1892 1139 - RSX Range of Intelligent Modems User Guide - v7.1 / Nov 2007
1Part One: Installation and Normal Operation
1.1 DIMENSIONS AND INSTALLATION
Unless supplied as an OEM PCB, the RSXn50G is supplied in a die-cast enclosure.
1.1.1 Standard Die-Cast Enclosure
Dimensions and mounting by means of four off M4 holes is shown in Figure 3.
Figure 3 Mounting details
Figure 4 - RSX in use
A whip antenna may be attached directly to the BNC
connector, and in this case the unit would typically
be mounted vertically. The antenna must be in a
suitable position - for example, against a metal
panel would not be suitable. See Figure 4.
Otherwise, the connection to the antenna should be
made with a short length of high-quality coaxial
cable. This is particularly important at higher
frequencies to avoid losses.
The data connector should be secured with screws
to the bushes provided for a reliable connection.