User guide

1892 1139 - RSX Range of Intelligent Modems User Guide - v7.1 / Nov 2007 33
Select Rx Offset A number of choices, multiples of the Comparison
Frequency, are offered.
Link
Read from Unit Reads data from the unit into the program, which is
then displayed on the screen. Until this command
has been issued, no data can be downloaded to
the unit.
Write to Unit Downloads data from the program to the unit. This
command can only be issued after a Read from Unit
command has been issued during the current
session.
Send e-mail Causes your default email application to create a
new blank email addressed to Wood & Douglas
technical support with the subject “SNx50".
Port Setup
Com Port Allows you to select one of the COM (serial) ports on
your machine to communicate with the SXn50G.
View
Main Menu Turns on and off display of the Main Menu window.
Internal EEPROM This displays the contents of the unit’s EEPROM in a
separate window. The data displayed is for the
functions and channels displayed on the main
screen at that time. Data can be hand-modified by
highlighting the data and over-writing it. Note that
the type of data in each field is displayed at the
bottom of the window.
Caution:This should only be carried out with full
knowledge of the internal working of the SXn50G.
It can render a unit unusable and require repairs
by Wood & Douglas if done incorrectly.
While this window is displayed, no access is
available to the main window. The window must be
cleared down by clearing the check mark against it in
the View menu.
Report File Displays a report on the current setup shown in the
main menu which can be printed if you wish.