Operating instructions

1892 1344 - SX450G Transceiver Operator Guide v1.7 / Nov 2007 21
Link
Read from Unit Reads data from the unit into the program, which is then
displayed on the screen. Until this command has been
issued, no data can be downloaded to the unit.
Write to Unit Downloads data from the program to the unit. This command
can only be issued after a Read from Unit command has been
issued during the current session.
Send e-mail Causes your default email application to create a new blank
email addressed to Wood & Douglas technical support with
the subject “SNx50".
Port Setup
Com Port Allows you to select one of the COM (serial) ports on your
machine to communicate with the SX450G.
View
Main Menu Turns on and off display of the Main Menu window.
Internal EEPROM This displays the contents of the unit’s EEPROM in a separate
window. The data displayed is for the functions and channels
displayed on the main screen at that time. Data can be hand-
modified by highlighting the data and over-writing it. Note that the
type of data in each field is displayed at the bottom of the window.
Caution: This should only be carried out with full knowledge
of the internal working of the SX450G. It can render
a unit unusable and require repairs by Wood &
Douglas if done incorrectly.
While this window is displayed, no access is available to the main
window. The window must be cleared down by clearing the check
mark against it in the View menu.
Report File Displays a report on the current setup shown in the main menu which can
be printed if you wish.
Help
About Displays information about Wood & Douglas, including website and
contact details.
Check for GUI Update Checks the Wood & Douglas website for updates and offers to
update your GUI if appropriate.