Operating instructions

16 1892 1344 - SX450G Transceiver Operator Guide v1.7 / Nov 2007
OBTAINING AND RUNNING THE PROGRAMMING SOFTWARE
1. Download the latest version of the programming software SXn50.exe from the
Wood & Douglas site on the internet. The URL (address) is:
www.woodanddouglas.co.uk
(In case of difficulty, contact Sales at Wood & Douglas, contact details on the last
page of this manual.)
2. Open the Zip file and run setup.exe, which will install the software for you.
3. Run the SXn50.EXE program. It will run in a normal window with both mouse and
keyboard support.
At this stage, the main window is displayed as shown in Figure 7.
Figure 7 - Programming screen
The screen shows the default settings which are displayed whenever the SXn50 software
is run.
The menu bar at the top lists a number of headings, under which there are usually
additional menu items, representing actions. Below this, there is the Frequency Table.
The leftmost column lists the channel numbers, and beside channels 0 to 63 are listed the
inverted binary equivalents used for parallel selection. The next column, TX Frequency,
is used to set and display channel frequencies.
Use the Port Setup > Com Port > COM1 etc. menu selection to select the port to which
your adaptor is connected.