Operating instructions

10 1892 1344 - SX450G Transceiver Operator Guide v1.7 / Nov 2007
Figure 5 - Parallel channel selection
CHANNEL SELECTION DURING OPERATION
There are three ways to select a channel during operation:
v In hardware, using six logic lines to select channels 0-63
v Using the SXn50.EXE software and a serial connection from a PC to the unit
v By sending a short serial data message to the unit from your own
equipment.
Parallel Channel Selection
v Whenever PL1 pin 6 , Mode Select, is logic high (>2.0V) or open-circuit, the
channel is determined by the six channel select inputs - that is, parallel
channel selection is in operation.
v Only channels 0 - 63 are available in this mode
The six channel select inputs are an inverse binary representation of the channel number,
that is, switch ON = input LOW = logic 1. If no connections are made, the unit therefore
defaults to channel 0.
Changes are implemented immediately.
The logic levels are : LOW < 0.8V
HIGH > 2V or floating