Operating instructions

6 1892 1210 - ST500 Transmitter Operating Instructions - v2.12 / May 2007
DESCRIPTION OF USER INTERFACE
Top Level Menu Bar (Outer Window)
File
Load Setting From Load a pre-stored set of data from a standard File Open dialog.
Save Setting To Save the current set of data. A default name is given which you can
change, and you can navigate to the directory of your choice.
Print Print the current set of data; only available when Report File window
is open. The currently selected Windows default printer will be used.
Exit Exit the program. Duplicates the Exit button.
View
Main Menu Turns on and off display of the Main Menu window.
EEPROM This displays the contents of the units EEPROM in a separate
window. The data displayed is for the functions and channels
displayed on the main screen at that time. Data can be hand-
modified by highlighting the data and over-writing it. THIS SHOULD
ONLY BE CARRIED OUT WITH FULL KNOWLEDGE OF THE
INTERNAL WORKING OF THE UNIT. Note that the type of data in
each field is displayed at the bottom of the window.
While this window is displayed, no access is available to the main
window. The window must be cleared down by clearing the check
mark against it in the View menu.
View Report File Displays a report on the current setup shown in the main menu which
can be printed if you wish.
Options Not currently used.
(Window List) Shows windows which can currently be displayed. When the
EEPROM window is displayed, Main Menu is removed from this list.
Unit Setup
Serial port COM Port: Select the serial port for the connection to the
unit, default COM1. Unavailable options are
greyed.
Baud Rate: Select the baud rate for communications with the
unit Unavailable options are greyed.
Osc Freq Displays the oscillator frequency, which is fixed by the
hardware and cannot be changed.