Operating instructions

1892 1210 - ST500 Transmitter Operating Instructions- v2.12 / May 2007 11
Parallel channel mode select must be the last action before disconnecting the unit: any
further serial communication will reset it to serial mode.
Completing Programming
This completes programming and the unit may be disconnected. It is not necessary to
switch off power or stop the program first.
Programming Further Units
Further units may be programmed by disconnecting one unit and connecting the next,
which may be done without switching the power off.
v If you want to use the channel frequency settings from the previous unit,
either as they are or as a basis for editing, do not stop the program, because
it does not save settings between sessions.
Proceed as above, using Program Unit when all the channel parameters are correct, and
selecting Program Serial Channel or Set Parallel Channel Mode before disconnecting the
unit.