User Manual

2.4G_433M-V6.1

Power and Standby Setup

Battery Reserve（show battery level）

Set the time for automatic shutdown

50 seconds shutdown

2 minutes shutdown-Default

5 minutes shutdown

30 minutes shutdown

Battery level indication

1. The scanner starts, when the buzzer rang “Di-di-di” and the blue light is on

with no red light flashing, it indicates that the battery is sufficient

2. The scanner starts, when the buzzer rang “Di-di-di” and the blue light is on

with the red light flashes three times, it indicates that the battery less than 30%,

please charge the scanner as soon as possible

3. The scanner starts, when the buzzer doesn’t make a sound and the blue

light is off with the red light flashes three times. It indicates that the battery less

than 20%. The scanner enters the low battery protection mode. Please charge

the scanner at least for 30 minutes before using

4. Press the button, the scanner does not respond. Please charge the scanner

at least for 30 minutes. If the scanner still cannot start, this indicates that the

battery is broken and needs to be replaced.

LED tips during charging

Plugged the USB cable into the USB port of computer

1. Charging mode: the blue light is on with the red light flashing

2. Charging completed: the blue light is on and the red light goes out

3. Micro-current charging: the blue light off and the red light flashing (Note:

This is battery protection phase, please do not use it in this condition)