User's Manual

QUICK START GUIDE
WIRELESS BLUETOOTH SPEAKER
For product support, visit: WWW.GEAR4.COM
BOX CONTENTS
Espresso Bluetooth Speaker
Charging cable
Quick Start Guide
OPERATING INSTRUCTIONS
LED Status and Modes
Blue LED flashes = Bluetooth Pairing
Solid Blue light = Paired
Solid Red light = Charging
LED off = Fully charged
Pairing and Connecting to your Espresso Bluetooth speaker
1) Short Press to turn on speaker. The speaker will automatically
enter pairing mode. Bluetooth indicator LED will flash blue.
2) Go to Bluetooth settings on your music device and connect to
“Espresso”. After connecting Bluetooth indicator LED will display
solid blue.
Note: If the Espresso is already connected to another Bluetooth device,
disconnect that device before connecting.
Charging your Espresso speaker
• Use the micro-USB cable to charge the speaker.
When charging the indicator LED will display solid red.
• When fully charged the red LED will turn off.
Volume control
Use your Bluetooth device to adjust
the volume up or down.
GEAR4 One-Year Warranty
Disruptive Hong Kong Limited, trading as GEAR4, warrants this product to be free from defects in workmanship
and materials at the point of sale. Subject to this product being used in accordance with its instructions for use,
the product shall continue to be free from defects, for a period of one (1) year from the date of original purchase.
Any damage or defects caused by a failure to follow the instructions which relate to this product or as the result
of an accident, abuse, misuse, misapplication, product modification, faulty ancillary equipment, improper
voltage or current, lightning or other acts of God, commercial non-home use, normal wear and tear, shipping
damage or loss, damage to digital media players or damage caused by the actions of anyone other than
Disruptive Hong Kong Limited are expressly excluded from the warranty stated above.
Disruptive Hong Kong Limited will, at its sole election, repair or replace any product that proves to be defective
in either or both of workmanship or materials and as covered by this warranty. If the product is no longer
manufactured or is out of stock at or after the time Disruptive Hong Kong Limited learns of the warranty claim,
Disruptive Hong Kong Limited may, at its sole election, replace your product with a similar product.
Disruptive Hong Kong Limited’s liability is limited to the repair or replacement, of any defective product under
warranty and any incidental or consequential damages are expressly excluded to the fullest extent permitted
by law. This warranty is not transferable and does not extend to users other than the person who originally
purchased the product.
Nothing in this manual shall limit or exclude liability of Disruptive Hong Kong Limited for death or personal
injury resulting from Disruptive Hong Kong Limited’s negligence, for fraud or fraudulent misrepresentation or
breach of the terms implied by Section 12 of the Sale of Goods Act 1979.
Handle clip
Press handle clip
to open, release
to close.
Power on/off
To turn Espresso
speaker on or off,
short press
This warranty gives you specific legal rights in addition to the ones afforded you by the laws of your country.
This warranty is not intended to operate to limit such legal rights.
Australian Consumer Law In Australia, the Trade Practices (Australian Consumer Law) Amendment Regulations
2010 (No. 1) apply. Our goods come with guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a major failure.
Return Policy / Warranty Service
Warranty claims will only be valid when proof of purchase is supplied to Disruptive Hong Kong Limited to
evidence that the product was purchased from an authorised Disruptive Hong Kong Limited dealer and that
the claim is within one (1) year of purchase. To make a warranty claim you must first contact Disruptive Hong
Kong Ltd, Rm 2002, 20/F King Palace Plaza , 52A Sha Tsui Road, Tsuen Wan, Hong Kong stating your name,
full postal address, contact telephone number, the name of the product and its serial number, date and place
of purchase and a detailed description of the problem you are experiencing.
If the defect is covered by this warranty then you will be provided with an authorisation number and
instructions for return shipment. Where possible, you must send to Disruptive Hong Kong Limited the
damaged or defective product. The returned product MUST be accompanied by the original proof of purchase.
We highly recommend that you retain a copy of this proof of purchase for your records.
Disruptive Hong Kong Limited shall not be responsible for lost or damaged products during shipment. Any
product returned without the original proof of purchase will be returned without being examined or tested
and such return shall be at the customer’s expense.
To avoid any additional charges, all returns and exchanges must include the original packing materials,
product box, all included accessories which may include, but not necessarily be limited to, power adapters
or power cords, connecting cables, remote controls, adapters, inserts, cards and instruction manuals. The
absence of any of the aforementioned items may mean that you incur a charge for their replacement.
Disruptive Hong Kong Limited shall not be liable for any indirect or direct consequential loss
IC: XXXXX-PS006 FCC:XXXXXPS006
Made in China Model No: PS006
Input: DC5V 500mA THIS ITEM IS NOT A TOY
DS-1370