User's Manual
76
ONE DAY ALARM (HOTEL SETTING)
This alarm clock is equipped with a 1-Day Alarm feature, which allows the alarm to be set 
for one day only. To activate this feature: 
1. Move the HOTEL switch located on the bottom of the CHILL to the ON position. Once 
this switch is in the ON position, the alarm time will need to be reset. 
2. Press and hold the desired alarm button (ALARM 1 or ALARM 2) located on the top 
of the CHILL. The hour will begin flashing.
3. Use the TUNER     buttons on top of the CHILL to adjust the hour, paying attention 
to the AM and PM indicators.
4. Press the alarm button again and the minute will begin flashing. Use the TUNER     
buttons again to adjust the minute.
5. Press alarm button again to adjust the maximum volume of the gradual wake feature 
(alarm begins soft and slowly gets louder) by using the TUNER     buttons to adjust 
the sound level up or down.
6. Press the alarm button again to select the source. The CHILL’s alarm can be set to 
Beep or to FM radio using the TUNER     buttons. The alarm cannot be set to the 
Bluetooth
®
 source.
Please note: When the 1-Day alarm feature is activated, the alarm will only sound for the 
1 day selected.
LISTENING TO A NON-BLUETOOTH
®
 AUDIO DEVICE 
1. Using the 3.5 mm audio cable (not included), plug in the device via the AUX audio line 
input located on the rear of the CHILL. 
2. Plug the other end of the audio cable into the line out or headphone jack of your 
audio device. 
3. Press the POWER button located on top of the CHILL. 
4. Press the SOURCE button on the unit until the AUX icon appears on the display. 
5. Press play on the connected device. 
NOTE: You may need to adjust the volume on your audio device to achieve 
proper volume. 
LISTENING TO THE FM RADIO (FIG. 1 & 2) 
NOTE: For best reception, fully extend the wire antenna. DO NOT strip, alter or attach to 
other antennas.
1. To listen to the radio, press the POWER button located on top of the CHILL. 
2. Press the SOURCE button on the CHILL until FM and station frequency appears on 
the display. 
3. Use the TUNER     buttons on the top of the unit to select desired station. 
4. Press the POWER button to turn unit off. 
LISTENING TO YOUR DEVICE WIRELESSLY 
OVER BLUETOOTH
®
To listen to your music using the Bluetooth
®
 wireless connection, you need to pair your 
device with the CHILL: 
1. Make sure your device has Bluetooth
®
 capability. 
2. Use the SOURCE button on the CHILL to select BLUETOOTH. BT icon
will 
appear on display
3. Follow the instructions of your device to pair the unit. 
4. Pair your device with the unit by selecting HMDX CHILL from your Bluetooth
®
 listings 
on your device or selecting YES. 
5. Press play on your device and use controls on the CHILL to adjust desired volume. 
NOTE: Once you have successfully paired your device, you typically will not need to 
repeat the above steps. Please ensure the AUX cable is unplugged, the unit source is set 
to Bluetooth
®
 and your device has Bluetooth
®
 enabled. The effective range for this mode 
is approximately 30 feet. 
DISPLAY DIMMER CONTROL (FIG. 2)
Press the SNOOZE / DIM / SLEEP bar to adjust the backlight intensity of clock display. 
The power needs to be off to use the dimmer control. 
USB CHARGING PORT
• This USB port is for charging only. It cannot be used to play music through the unit. 
• In order to use the USB charging feature, you must have the proper cord to connect to 
your device with a USB Type A connector on the other end. 
To charge your device using the USB charging port (located on the back of the unit): 
1. Connect the USB type A end of the device’s cable into the USB port on the rear 
of the CHILL. 
2. Connect the other end of the USB cable to your device to begin charging. 
VOLUME CONTROL (FIG. 2)
To adjust the volume, use the volume +/- buttons to select the desired level.
SLEEP FEATURE 
While listening to the Bluetooth
®
, radio or AUX sources, press the SNOOZE button to 
activate the sleep feature. This allows you to set a sleep timer for 90, 80, 70...10, or 
5 minutes. Once set, the unit will continue playing for the set length of time, then will 
automatically turn off.





