User Manual

7. Make sure the power cable is plugged in. Turn the mill on.
8. Fill the hopper with grain.
Remember, The first time you use your WonderMill:
Mill at least 400 grams of wheat or other hard grain, then discard the
flour. This will eliminate any contaminates the mill may have
obtained in the manufacturing process. Make sure the grain you use
is clean. We recommend triple cleaned grains from a reputable
source. Remember, your warranty does not cover foreign object
damage from plastics, metals, rocks, or any other material that could
get into and damage the milling heads. Proper care of your mill will
help to ensure a reliable milling experience for years to come.
9. When the mill has finished grinding, you will hear a noticeable
change in the way the mill sounds (higher pitch). After the hopper
is empty allow the mill to run for approximately five seconds. This
creates a self-cleaning action in the grinding chamber.
10. Do not continuously add grain to the hopper while the mill is
running. If you do this you will overfill your canister.
11. After you have finished milling and switched off the motor, unplug
the power cable from the power outlet. Separate the canister from
the mill by pulling the tube straight out of the flour outlet. Then you
can remove the separator lid from the canister. You can use your
fresh flour immediately or snap on the storage lid and use it later.
12. CLEANING:
We suggest that you clean your separator lid, cup and filter after
each use. Simply dust off with a fine pastry brush or paint brush.
THE FLOUR TUBE CANNOT BE REMOVED FROM THE
SEPARATOR LID: rotate it back into the storage position. The
hopper and the body of the mill can be wiped clean with a damp
cloth. NEVER immerse the mill in water and don’t let water run
into the grinding chamber from the hopper.
5
IF YOUR WONDERMILL BECOMES CLOGGED
1. Unplug power cord from the electrical outlet.
2. Remove flour tube from the flour outlet and turn texture knob to far right
coarse setting (3 o'clock position).
3. Tip the flour mill upside down, while holding the mill firmly, and tap the
side of the machine lightly to remove any remaining grain from the
hopper.
4. Remove any flour that may be packed in the flour outlet and flour tube (if
you have a canister type Hoover with a hose this works well to clear any
clogged flour).
5. Reassemble your WonderMill.
6. Plug the power cable into an power outlet.
7. Turn the power switch on. Your WonderMill should begin to run
normally, but if it doesn’t and the fuse on the bottom of the machine pops
then wait 2 minutes, push the button to reset the fuse, and repeat the above
steps1-7. If this fails to start the mill please call us at [phone].
8. Once your WonderMill runs normally then any grain that was left in the
grinding chamber will flow into the canister.
9. Let the mill run empty for approximately 2 minutes, then add 100 grams
white rice into the hopper, this will help clean out the grinding chamber.
This flour should be discarded.
10. Repeat this process as many times as necessary to clear the grinding
chamber.
If this does not clear the WonderMill please contact the service
center (their number is on the back of the warranty manual).
REMEMBER, MOISTURE IS YOUR WORST ENEMY!
Always store your grain in an air tight container.
6