Users Manual
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)
This
device
may
not
cause
harmful
interference,
and
(2)
this
device
must
accept any interference received, including interference that may cause undesired operation.
FCC ID:2AQIRWDCTC-01
FCC statement
This
equipment
has
been
tested
and
found
to
comply
with
the
limits
for
a
Class
B
digitaldevice,
pursuant
to
Part
15
of
the
FCC
Rules.These
limits
are
designed
to
provide reasonable protection against harmfulinterference in a residential installation.
This
equipment
generates,
uses
and
canradiate
radio
frequency
energy
and,
if
not
installed and used in accordance withthe instructions, may cause harmful interference
to radio communications.
ainoccurnotwillinterferencethatguaranteeHowever, there is no
particularinstallation.
·If this equipment does cause harmful interference to radio or televisionreception,
which can be determined by turning the equipment off and on, theuser is encouraged
to try to correct the interference by one or more of thefollowing measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment andreceiver.
—Connect the equipment into an outlet on a circuitdifferent from that to whichthe
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure warning
·The equipment complies with FCC RF exposure limits set forth for anuncontrolled
environment.
The equipment must not be co-located or operating in conjunction with anyother
antenna or transmitter.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subjectto
the following two conditions: (1) this device may not cause interference, and (2) this devicemust
accept any interference, including interference that may cause undesired operation of thedevice.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radioexempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillageradioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.