User Manual

9
Connect power adapters to both transmitter and speakers and power
them on.
Connect audio source to transmitter, by either LINE-IN or Bluetooth, and
PLAY the audi o sou rce. You must have audi o sig nal go into the
transmitter before pairing .
Press and hold the PAIRING button located on the far right of the back of
the transmitter about 3 seconds until the TR-SP SYNC LED on the
transmitter starts flashing. Release the PAIRING button.
Press and hold the PAIRING button located on the far left of the top of
speaker about 3 seconds until the speaker gives one LONG BEEP, and
the SYNC LED on the speaker starts flashing. Release the PAIRING
button.
If the pairing process is successful, both SYNC LEDs will stop flashing
and the speaker will play the music.
In case of channel interference, repeat the pairing process one more time
to allow the Wolverine to select a different channel (frequency).
.
.
.
.
.
.
3. Pairing
All new WIOS-5.8 Speaker System was pre-paired at manufacturing facility,
pairing process is not needed. In any case if user wants to pair the system,
please follow the steps below.
Each transmitter can connect with more than one speaker (up to 8 speakers).
You can pair additional speakers to the transmitter by following the steps:
You have to use the POWER button on top of the speaker unit to power
on the speaker the VERY FIRST TIME you set up the Wolverine system.
Subsequently, you can use the remote control to operate the Wolverine
system accordingly.
You can turn on or off the VSS (Virtual Surround Sound) feature of the
WIOS-5.8 system only with your remote control. Press VSS ON/OFF to
turn the feature on/off.
4. Remote Control
.
.
.