User Manual

8
2. Prepare Speaker receiver
Plug the supplied Power Adapter to an electrical wall outlet, insert the
connector to the DC jack, or install 6 "AA" size quality ALKALINE
batteries (not included) into the battery compartment with correct
polarity, at the bottom of the speaker.
Press and hold the POWER ON/OFF button to turn on the speaker.
The Power LED will be on.
When the transmitter is connected with an operating audio device,
the SYNC LED will be steady on, and the speaker will start playing.
Adjust the volume by pressing the VOL+ or VOL- buttons.
A. Audio receiving
.
.
.
.
You can select the audio channel by using the audio channel switch
on the bottom of the speaker unit.
You can select Left channel (L), Right channel (R), or VSS (M) for
virtual surround sound.
To listen in stereo mode, switch one speaker to Left channel, and
the other speaker to Right channel.
B. Audio channel selection
.
.
.
To power off the speaker, you can press and hold the POWER
button once, or aim the remote control at the speaker's IR sensor
and press the POWER button on the remote.
When the speaker did not receive audio signal for more than 10
minutes, it automatically shuts off the link with the transmitter and
goes into standby mode with SNYC LED turned off.
You can wake up the WIOS-5.8 system by simply playing audio.
C. Standby/Power Off
.
.
Each speaker has built-in ambiance LEDs. Press the LIGHT button
to turn on the LED lights, press it again to turn off the LED lights.
D. Ambiance Light
.
For easy carrying or hanging, the speaker has a handle located on
the top of the speaker.
E. Carry Handle
.