Product Manual

16. Position the backing plate on the mounting surface and secure using the two sheet metal screws provided
that have the countersunk head.
17. The control panel is carefully pushed onto the backing plate.
WIRING SWITCH CONTROL PANEL TO 12-24 VOLTS. Fig. F
WARNING: The power supply has an external 15-amp fuse to
protect its internal circuit. The 15-amp in-line fuse attached to the
red wire must be connected “AT A POWER SOURCE” so to protect
the wire connection between the power source and power supply.
18. BLACK WIRE: Is connected to ground (-). Secure the BLACK to
the negative battery post or under any metal body bolt. Make
sure that the METAL surface around the bolt that secures the
wire is clean of rust and paint so to make a good electrical
connection.
19. RED WIRE: Is connected to 12-24 volts (+) positive. Using the
inline fuse provided, connect the red wire to the vehicles fuse
block or (+) positive battery post. Remove fuse from the inline fuse holder until all wiring is completed.
20. The plug with the YELLOW wire is connected to the power supply in the position marked “CONTROL’’.
21. The plug with the RED & BLACK wires is connected to the power supply in the position marked “12-24
VOLTS”.
22. Inspect all wiring and make sure all connections are secure. Install fuse back into the inline fuse holder.
INSTALLATION IS COMPLETE
Position the on/off switch to “ON“. Press and release the push button to change the light pattern.
Flash Pattern
Strobe Sequence
1. Triple Fast Flash L6 & L5 – L4 & L3 – L2 & L1
2. Double Flash L1, L3 & L5 – L2, L4 & L6
3. Single Fast Flash L6 – L5 – L3 – L1 – L4 – L6
4. Single Fast Flash L1 – L3 – L5 – L6 – L4 – L2
5. Double Flash L3 & L4 – L5 & L6
6. Double Flash L5 & L6
DESCRIPTION OF LIGHT PATTERN
Pattern 1. Lights L6 & L5 - L4 & L3 - L2 & L1 function together
Pattern 2. Lights L1, L3 & L5 - L2, L4 & L6 function together
Pattern 3. Lights L6 – L5 - L3 – L1 – L2 – L4 function individually
Pattern 4. Lights L6 – L5 - L3 – L1 – L2 – L4 function individually
Pattern 5. Lights L3 & L4 - L5 & L6 function together
Pattern 6. Lights L5 & L6 function together
SPECIFICATIONS
Input Voltage: 12-24 VDC
Current: 5.8 amps @ 12.5 VDC
Output Power: 120 Watts
Flash Patterns: 6
Output circuit protection
Included: Four cables 3 meters / 9.8 ft in length with locking connectors
Included: Two cables 5 meters / 16.4 ft in length with locking connectors
Included: Switch control panel
Power Supply Dimensions: L 5-3/4 in. x W 5-5/8 in. x H 2-1/8 in.
Fig. F
B
LA
C
K
RED
POWER SUPPLY
RED
EXT FUSE
15 AMP