Product Manual

4. Select a position in the headlight, marker light or taillight assembly that is flat so that the bulb’s grommet will
make a good waterproof seal once installed.
5. Using a 1” hole saw, cut a hole in the light assembly in the selected location and de-burr hole.
6. Clean the interior of light assembly and lens of any dust or filings, which may have developed during cutting
the hole.
7. Re-install the OEM factory light assembly and reflector.
8. Install the strobe bulb into the one inch hole drilled into the light
assembly. Hold the bulbs rubber grommet and use a twisting
motion while pushing inward until the grommet’s recessed ring
engages into the light’s assembly.
9. Repeat the same installation procedure for the remaining bulbs.
WIRING STROBE BULBS Fig. C
IMPORTANT: To prevent damage to the power supply, DO NOT
connect any power source until all of the strobe bulbs are
completely wired to the power supply.
LIGHTNING PLUS comes with six (6) cables that are used to connect the strobe bulbs to the power supply.
Each cable has two female plugs, one at each end. The plugs are different and will only connect to its mate,
the bulb, or power supply.
10. Four of the cables are 3 meters / 9.8 ft. in length and should be used to connect the vehicle’s front strobe
bulbs to the power supply position L1, L2, L3 & L4.
11. Two of the cables are 5 meters / 16.4 ft. in length and should be used to connect the vehicle’s rear strobe
bulbs to the power supply position L5 & L6.
NOTE: If you need to lengthen the rear cables, see chart below for proper wire gauge.
16-30 ft.
31-50 ft.
Use 18 Gauge or heavier Use 16 Gauge or heavier
MOUNTING SWITCH CONTROL PANEL
Using double face tape or screws
TAPE METHOD
12. Select a mounting location for the control panel that is easy to reach. IMPORTANT: Be sure that the
switch control panel or its wires will not interfere with air bags or the driver’s vision.
13. Using the double-sided foam adhesive tape provided, mount the control
panel to selected location. Make sure that mounting surface is free from
dust, wax etc. A clean surface is necessary so that double-sided tape will
hold properly.
IMPORTANT: THE ADHESIVE HOLDING POWER BECOMES MAXIMUM
IN ABOUT 24 HOURS. LIMIT MOVING OR PUTTING PRESSURE ONTO
THE KEYBOARD UNTIL THEN.
SCREW METHOD Fig. D & E
14. Remove the control panel’s backing plate using a flat tip screwdriver.
15.Using the backing plate as a template, mark the two hole locations onto
the mounting surface where the switch panel will be mounted and drill to
size using a 3/16” drill. IMPORTANT: The installer must carefully inspect
both sides of the mounting location before drilling any holes to ensure
that there are no components, wires and or any vehicle part that could
be damaged by drilling.
Fig. C
Fig. D
Fig. E
HOLE SIZE
3/16”