Product Manual

WIRING SWITCH CONTROL PANEL TO 12-24 VOLTS. Fig. F
WARNING: The power supply has an external 15-amp fuse to protect its internal circuit. The 15-amp in-line
fuse attached to the red wire must be connected “AT A POWER SOURCE” so to protect the wire connection
between the power source and power supply.
18. BLACK WIRE: Is connected to ground (-). Secure the BLACK
to the negative battery post or under any metal body bolt.
Make sure that the METAL surface around the bolt that
secures the wire is clean of rust and paint so to make a good
electrical connection.
19. RED WIRE: Is connected to 12-24 volts (+) positive. Using
the inline fuse provided, connect the red wire to the vehicles
fuse block or (+) positive battery post. Remove fuse from the
inline fuse holder until all wiring is completed.
20. The plug with the YELLOW wire is connected to the power
supply in the position marked “CONTROL’’.
21. The plug with the RED & BLACK wires is connected to the
power supply in the position marked “12-24 VOLTS”.
22. Inspect all wiring and make sure all connections are secure. Install fuse back into the inline fuse holder.
INSTALLATION IS COMPLETE
Position the on/off switch to “ON“. Press and release the push button to change the light pattern.
Flash Pattern
Strobe Sequence
1. Triple Fast Flash L1 & L4 – L2 & L3
2. Triple Flash L1, L2 , L3, L4
3. Rapid Rate L1 & L3 – L2 & L4
4. Action Flash L1 & L4 – L2 & L3 – L1 – L2 – L3 – L4
5. Triple Flash L1 & L4
6. Triple Flash L2 & L3
DESCRIPTION OF LIGHT PATTERN
Pattern 1. Lights L1 & L4 - L2 & L3 function together
Pattern 2. All lights function together
Pattern 3. Lights L1 & L3 - L2 & L4 function together
Pattern 4. Lights L1 & L4 - L2 & L3 function together then all lights function together
Pattern 5. Lights L1 & L4 function together
Pattern 6. Lights L2 & L3 function together
SPECIFICATIONS
Input Voltage: 12-24 VDC
Current: 4.15 amps @ 12.5 VDC
Output Power: 80 Watts
Flash Patterns: 6
Output circuit protection
Included: Two cables 3 meters / 9.8 ft in length with locking connectors
Included: Two cables 5 meters / 16.4 ft in length with locking connectors
Included: Switch control panel
Power Supply Dimensions: L 5-1/2 in. x H 5-3/8 in. x D 1-3/4 in.
Fig. F
B
LA
C
K
FUSE
15 AMP
RED
POWER SUPPLY
RED
EXT FUSE
15 AMP