Product Manual

WIRING POWER CABLE See fig 8
Cable that has two wires (red and black)
20. WARNING: Failure to wire the light bar correctly could result in permanent damage to the light bar, the
vehicle’s electrical system and/or cause a fire. If any switch, fuse or wire is replaced, they must meet
or exceed specifications rating specified in this manual. Any deviation to the electrical specifications is
at the installers/users risk. IMPORTANT: Disconnect the vehicles battery before beginning any wiring.
IMPORTANT: The RED wire must be connected to the 10 amp inline fuse (included with light bar) at the
point of the 12-volt connection such as the fuse block, the vehicle’s battery or any 12-volt power source
which is rated by vehicle’s manufacturer capable of handling 10 amps. The fuse should never be more then
ten (10) inches from the power source. If either the red or black wires need to be lengthened use 18 gauge
or heaver wire.The light bar is a low current device, to operate this product at peak performance make sure
all connections are clean of paint, rust and corrosion and firmly secured.
21. RED & BLACK WIRES:
Route the wires to the
vehicles fuse block,
accessory source or
battery. If the power wires
pass through any drilled
holes or firewall, always
use a rubber grommet to
protect the wire cables.
22. BLACK WIRE: Connect to
ground by securing wire
under any metal body bolt
or the negative (-) battery
post. Make sure that the
METAL surface around the
bolt that secures the wire
is clean of rust, oxidation
and paint to make a good
electrical connection.
23. RED WIRE: Connect to positive (+) 12-volts such as the fuse block, accessory power source in the
dashboard area or the positive (+) battery post. Always use the provided 10-amp inline fuse. Make sure the
connection is at a location free from corrosion or oxidation.
24. BROWN WIRE: Connect to the wire that provides (+) 12-volts to the vehicle’s right side brake lights (drivers
side) when the brake pedal is depressed. Always install the 3-amp fuse provided as shown in fig. 8
25. WHITE WIRE: Connect to the wire that provides (+) 12-volts to the vehicle’s left side brake lights
(passenger side) when the brake pedal is depressed. Always install the 3-amp fuse provided as shown in
fig. 8.
To prevent shorts make sure all wire connections are properly insulated.
26. Make sure all wires are securely fastened to vehicle using plastic wire ties or electrical tape (not provided).
WARNING: Carefully inspect the interior driver’s area to make sure the light bar wires or the vehicle’s
electrical system wires are not interfering with the operation of vehicle’s controls; accelerator, brake, clutch
pedals and etc.
27. Reconnect the vehicle’s battery. Installation is complete.
OPERATING LIGHT BAR
28. The switch controller has an on/off switch located at the top left corner, position the switch to ON. There is
a power indicator light that will illuminate on the front panel of the switch controller directly under the word
POWER.
Right
Light
Left
Light