Product Manual

WOLO LUXOR MODELS - PAGE 4
WIRING POWER CABLE See g 7
Cable that has two wires (red and black)
21. WARNING: Failure to wire the light
bar correctly could result in permanent
damage to the light bar, the vehicle’s
electrical system and/or cause a
re. If any switch, fuse or wire is
replaced, they must meet or exceed
specications rating specied in this
manual. Any deviation to the electrical
specications is at the installers/users
risk. IMPORTANT: Disconnect the
vehicles battery before beginning any wiring. IMPORTANT: The RED wire must be connected to the 15-
amp inline fuse (included with light bar) at the point of the 12-volt connection such as the fuse block, the
vehicle’s battery or any 12-volt power source which is rated by vehicle’s manufacturer capable of handling
15-amps. The fuse should never be more then ten (10) inches from the power source. If either the red or
black wires need to be lengthened use 16 gauge or heaver wire. The light bar is a low current device, to
operate this product at peak performance make sure all connections are clean of paint, rust and corrosion
and rmly secured.
22. RED & BLACK WIRES: ROUTE the wires to the vehicles fuse block, accessory source or battery. If the
power wires pass through any drilled holes or rewall, always use a rubber grommet to protect the wire
cables.
23. BLACK WIRE: Connect to ground by securing wire under any metal body bolt or the negative (-) battery
post. Make sure that the METAL surface around the bolt that secures the wire is clean of rust, oxidation
and paint to make a good electrical connection. See g 7.
24. RED WIRE: Connect to positive (+) 12-volts such as the fuse block, accessory power source in the
dashboard area or the positive (+) battery post. Always use the fuse holder provided with the 15-amp fuse.
Make sure the connection is at a location free from corrosion or oxidation. See g 7.
25. To prevent shorts make sure all wire connections are properly insulated.
26. Make sure all wires are securely fastened to vehicle using plastic wire ties
or electrical tape (not provided). WARNING: Carefully inspect the interior
driver’s area to make sure the light bar wires or the vehicle’s electrical
system wires are not interfering with the operation of vehicle’s controls;
accelerator, brake, clutch pedals and etc.
27. The cable white plug is connected to it’s mate located on the back of the
switch controller. The plug is designed only to connect in one position.
NOTE: The plugs locking tab is inserted facing downward. See g 8.
OPERATING LIGHT BAR
POWER SWITCH: Turns power on/off. There is a power indicator light above switch that will illuminate when
power to the light bar is turned on.
FRONT LIGHT: Turns on/off the LED modules on the front of the light bar. Press and release front light switch
and the light pattern will change: STEADY ➜ ALTERNATING ➜ SYNCHRONOUS ➜ OFF
REAR LIGHT: Turns on/off the LED modules on the rear of the light bar. Press and release rear light switch
and the light pattern will change: STEADY ➜ ALTERNATING ➜ SYNCHRONOUS ➜ OFF
ALLEY LIGHT: Turns on/off the clear LED modules on the left & right sides of the light bar. Press and release
the alley light switch and the light pattern will change: STEADY ➜ ALTERNATING ➜ SYNCHRONOUS ➜ OFF
Fig. 7
Fig. 8
➜